What to do if Lost BIOS password!

If the password is provided by the manufacturer that produces the BIOS, then please semaknya by the manufacturer.

This is to determine whether the manufacturer has provided a standard password by default to the BIOS.

For example, the BIOS issued by the Award or Award BIOS provides a password like AWARD SW, AWARD_SW, Award SW, AWARD PW, _award, awkward, J64, j256, j262, j332, j322, 01322222, 589589, 589721, 595595 , 598598, HLT, Ser, SKY_FOX, Ally, Ally, Condo, CONCAT, TTPTHA, aPAf, HLT, KDD, ZBAAACA, ZAAADA and ZJAAADC.

You can do this by first identifying the manufacturer of the BIOS used.

With this, try doing an Internet search using the search engine or contact the manufacturer of the BIOS.

If the password is set by someone forgot the password, so it can be reset to reset the system BIOS or reflashed by using software or hardware.

For the method to reset the system BIOS using the software, we need to reach the computer that is being run, or log.

If unable to reach the computer is run, the method to reset the system BIOS using the hardware can be used.

Method to reset the system BIOS using the software can be done by visiting the manufacturer's website.

Next, download a program to reset the system BIOS provided by the manufacturer.

Use the program to reset the system BIOS of your computer.

In addition to computer programs provided by the manufacturer, may also use the programs produced by third parties.

However, the need to ensure they are suitable for the use of the system BIOS. For example, use MS DEBUG. However, it must know how to use it.

For the method to reset the BIOS using a tool, it needs to be known as a jumper switch located on the main board. This jumper must be reset to reset the system BIOS.

The method is as follows:

1. See manual for architecture the main board or motherboard of the computer. Identify the location of the BIOS jumper is on the main board. Normally, this jumper has three pins and the jumper will find two of the three pins. This configuration can be seen in the manual the main board.

2. Make sure the computer is switched off. Next, disconnect the jumper from the pins.

3. Insert the jumper back on pins contrary to the original configuration. For example, if the original is placed on the jumper pin 1 and pin 2. So, we are placing the jumper back to pin 2 and pin 3. please refer to your main board manual.

4. Please wait for a few seconds.

5. Next return to the configuration of the jumper pin location of the original.

6. Finally, open your computer as usual.

Among other methods can be used to reset the system BIOS is to disconnect the CMOS battery is in the main board. Prior to that, make sure you turn off the computer. After disconnect, can restart your computer. With this, the password for the BIOS you will not.
>Megabait utusan